Skip to content
Toilet clog cleared with an auger, Rooter-Man Plumbing of Tacoma

Water Heater Replacement in Gig Harbor

Gig Harbor, WA · Pierce County

Rooter-Man Plumbing of Tacoma offers water heater replacement in Gig Harbor, about 30 minutes from our base on Tacoma's southeast side.

  • Family- and veteran-owned
  • Licensed, bonded and insured
  • 20+ years of trusted local service

At a glance

Gig Harbor is in Pierce County. We head out on SR 16 across the Tacoma Narrows Bridge, roughly 18 miles. A $49 diagnostic fee finds the cause and is waived when you approve the repair, and you get a flat-rate price before work begins.

  • 18 mi

    From our base on Tacoma's southeast side.

  • 30 min

    Typical drive from our Tacoma base.

  • $49

    Diagnostic fee, waived when you approve the repair.

  • Flat rate

    Your price, parts and labor included, before work begins.

Signs your Gig Harbor home needs water heater replacement

  • Water leaking from the tank body
  • Rusty water from hot taps only
  • Repairs keep stacking up
  • Not enough hot water anymore
  • Loud rumbling that a flush did not fix
  • Rust on the top fittings

Tank leaking or past its prime? Call any hour and a real person will help you plan the swap. Call (253) 600-1335

How long it takes

Like-for-like tank swap2 to 4 hours typical
Swap with upgrades4 to 6 hours typical
Draining the old tankUp to 1 hour typical

Typical times on site. Gig Harbor is about 30 minutes from our base.

Water Heater Replacement in Gig Harbor: what is different here

For a Gig Harbor home on a well, iron or hardness may have shortened the life of the old tank, so we talk about that before the new one goes in. Check with the City of Gig Harbor, or Pierce County outside city limits, about permits. We come across the Narrows Bridge on SR 16 to Rosedale and Arletta.

Where we work in Gig Harbor

  • Downtown waterfront
  • Peacock Hill
  • Canterwood
  • Rosedale
  • Purdy
  • Point Fosdick
  • Wollochet
  • Arletta
  • Kopachuck
  • Harbor Hill

How the job runs

  1. Check the old setup

    We check the tank, gas or power, venting, water lines and space, and ask how much hot water you use.
  2. Size and price it

    We match the tank to your household and give one flat-rate price with parts and labor included before work begins.
  3. Remove and install

    We drain and disconnect the old tank, set the new one, connect water and fuel, and add an expansion tank if needed.
  4. Test and walk through

    We fire it up, check for leaks and venting, test the relief valve, clean up and show you the controls.

Talk to us about water heater replacement in Gig Harbor

A real person answers 24/7. You get a flat-rate price before any work begins.

What affects the price

Tank sizeLarger tanks cost more and may need a bigger space or new connections.
Gas or electricGas tanks need venting and a gas connection. Electric tanks need the right circuit.
Travel to Gig HarborAbout 30 minutes from our base via SR 16 across the Tacoma Narrows Bridge.

Water Heater Replacement questions in Gig Harbor

Often, yes. Most replacements are done the same day, depending on the tank you need and your setup. For a Gig Harbor home, about 30 minutes from our base across the Narrows Bridge, we confirm size and venting by phone so the right tank comes on the first trip when possible.

Here is what is typical once we are on site. Like-for-like tank swap: 2 to 4 hours typical. Swap with upgrades: 4 to 6 hours typical. Gig Harbor is about 30 minutes from our base via SR 16 across the Tacoma Narrows Bridge. We confirm timing with you when you book.

It varies with water quality, use and upkeep. A tank that was flushed and checked over the years tends to last longer than one that was ignored. When the tank leaks from the body or the hot water turns rusty, it is usually time to replace it.

Water Heater Replacement in Gig Harbor

A real person answers 24/7, and our regular hours are Monday to Saturday, 8 AM to 5 PM.