Skip to content
Toilet clog cleared with an auger, Rooter-Man Plumbing of Tacoma

Water Heater Repair in Des Moines

Des Moines, WA · King County

Rooter-Man Plumbing of Tacoma offers water heater repair in Des Moines, about 35 minutes from our base on Tacoma's southeast side.

  • Family- and veteran-owned
  • Licensed, bonded and insured
  • 20+ years of trusted local service

At a glance

Des Moines is in King County. We head out on I-5 north, roughly 20 miles. A $49 diagnostic fee finds the cause and is waived when you approve the repair, and you get a flat-rate price before work begins.

  • 20 mi

    From our base on Tacoma's southeast side.

  • 35 min

    Typical drive from our Tacoma base.

  • $49

    Diagnostic fee, waived when you approve the repair.

  • Flat rate

    Your price, parts and labor included, before work begins.

Signs your Des Moines home needs water heater repair

  • No hot water at all
  • Hot water runs out too soon
  • Pilot light will not stay lit
  • Popping or rumbling sounds
  • Water near the base
  • Rusty or smelly hot water

Out of hot water at a bad time? A real person answers 24/7 and can get a technician on the way. Call (253) 600-1335

How long it takes

DiagnosisUp to 1 hour typical
Common part repair1 to 2 hours typical
Tank flushAbout 1 hour typical

Typical times on site. Des Moines is about 35 minutes from our base.

Water Heater Repair in Des Moines: what is different here

Des Moines has many mid-century hillside homes above Puget Sound, around Zenith and Woodmont, where the water heater may sit on a lower level or in a tight utility space. We cover Des Moines from our base, about 35 minutes up I-5 north, and fix ignition, element and valve problems with the price set first.

Where we work in Des Moines

  • Marina District
  • Redondo
  • Woodmont
  • Zenith
  • Pacific Ridge
  • North Hill
  • Saltwater State Park area
  • Wooton Park area

How the job runs

  1. Test and find the fault

    We check the gas supply or power, the burner or elements, the thermostat and the valves to find the real cause.
  2. Give a flat-rate price

    You hear the fix and the price first. If the tank is failing, we say so.
  3. Make the repair

    We swap the failed part, flush if needed and check for leaks at every fitting and valve.
  4. Test and clean up

    We bring the tank back to heat, check the relief valve and clean up the work area before we go.

Talk to us about water heater repair in Des Moines

A real person answers 24/7. You get a flat-rate price before any work begins.

What affects the price

Gas or electricGas parts like igniters and sensors differ from electric elements and thermostats.
Which part failedA thermocouple swap is simpler than a gas control valve or a new element pair.
Travel to Des MoinesAbout 35 minutes from our base via I-5 north.

Water Heater Repair questions in Des Moines

A rotten egg smell from hot water usually comes from a reaction between the anode rod in the tank and the water, not a gas leak. If you smell gas near the heater itself, leave the house and call the gas utility. Otherwise, in Des Moines we can flush the tank and check the anode rod.

Here is what is typical once we are on site. Diagnosis: up to 1 hour typical. Common part repair: 1 to 2 hours typical. Des Moines is about 35 minutes from our base via I-5 north. We confirm timing with you when you book.

On a gas tank, the pilot, igniter or flame sensor is the most common cause. On an electric tank, it is often a tripped reset button or a burned-out element. Check that the gas valve is on or the breaker is not tripped, then call us if it still will not heat.

Water Heater Repair in Des Moines

A real person answers 24/7, and our regular hours are Monday to Saturday, 8 AM to 5 PM.